少儿英语游戏之纸折青蛙的英语步骤详解

　　下面就是纸折青蛙的英语步骤详解：

　　How to Make an Origami Jumping Frog

　　With nothing more than a piece of paper, you can construct a frog. Throughout these instructions, the dotted lines are where you will fold on the next step. Click on any picture to enlarge it.

　　1.Start with a sheet of paper. You can use ordinary computer paper, colored paper, or origami paper.

　　2.Fold one corner diagonally down to the opposite edge, so it will make an X shape out of the creases when you unfold it.

　　3.Open it back up and fold the paper on the other diagonal

　　4.Trim any extra paper outside of the square you just made, as shown. Skip this step if you are already using square (origami) paper. True origami only uses folding to create shapes--that means no cutting or tearing.

　　5.Open the square back up and fold it backwards, across the intersection of the two diagonal lines.

　　6.Open the paper again and push in the sides.

　　7.Form a triangle

　　8.Fold the outside corner up to the top point

　　9.Fold the other corner up.

　　10.Fold the new corner in, towards the center line.

　　11.Fold the other corner in towards the center

　　12.Now fold the top corners back out, until the edge is even with the edge underneath.

　　13.Repeat folding the top corners, as shown above, except on the other side

　　14.Turn the paper over

　　15.Fold the outer corners towards you, into the center.

　　16.Fold the outer corners back out, so that theyre even with the outside edges. Youre almost done.

　　17.Fold the frog in half.

　　18.Turn the frog over so the legs are facing away from you. Now fold those in half so it looks like the picture.

　　19.Ribbit!

　　Jumping Frog

　　Fold the paper in half sideways to make a rectangle.

　　Fold the corners down and unfold them right away, repeating this for both top corners of your rectangle.

　　Flip the paper over and fold the top of the paper down at the spot where the diagonal creases meet. Unfold right away.

　　Flip over once again, and fold the two edges toward you so they meet each other. The top of your rectangle will fold down to form a triangle.

　　Fold the bottom of the paper up so that its edge meets the bottom of your triangle. Fold the two corners of the triangle up to form the front legs of the frog.

　　Fold the sides inward to meet at the center.

　　Fold the bottom of the paper upward so its edge touches the bottom of the legs, and unfold right away.

　　Insert your fingers into the inside of the flaps, and pull the bottom corners

　　outward to the sides, so that the bottom edge comes up to touch the bottom of the legs.

　　Fold the corners down so they meet at the bottom of the figure.

　　Fold the bottom corners outward to form the back legs of the frog.

　　Create a zigzag fold at the bottom of the figure, folding the bottom half up and then the bottom quarter back down.

　　Your frog is ready to go.

　　折纸：oirgami 折叠：fold 展开：unfold 峰痕：mountain fold 谷痕：Valley fold 将纸张的一个边折向另一个边：turn the paper from side to side 将顶边折向底边：turn the paper from top to bottom

　　还有旋转纸张 rotate the paper 压进去：push here

　　折痕你就用crease ，水平折痕就是horizontal crease 垂直折痕则为 vertical crease

　　00A.

　　what the front side of the paper we will be using in these instructions looks like.

　　00B.

　　what the back side of the paper we will be using in these instructions looks like.

　　The back side is the same as the front side.

　　01.

　　Let us start with paper.

　　Prepare to valley-fold and then unfold

　　02.

　　Unfold the paper so that you can see the crease that you have just made.

　　*we have used a red pen to distinctively show the crease

　　Prepare for two valley-folds.

　　03. two valley-folds shown in the step #2.

　　Prepare to rotate the by 67.5 in the clockwise direction.

　　04.

　　Rotate the paper by 67.5 degrees in the clockwise direction so that the slanted vertical lineof edge

　　becomes a horizontal line.

　　Prepare for a valley fold in half.

　　05.

　　Valley-fold according to the step #4.

　　06.

　　Unfold the previous valley-fold.

　　Prepare to apply two valley-folds.

　　07.

　　Valley fold along two red dash-line in the step #6.

　　Prepare to turn the over.

　　08.

　　Turn the model over.

　　Prepare for two valley-folds.

　　Make sure to apply two valley-folds to the frontmost layer only.

　　This video tutorial will show you how to make an easy origami rose, which looks beautiful when grouped together into a bouquet. The tutorial itself shows how to make one rose, but if you wish to turn it into a bouquet, simply add some stems and leaves, and make a few. Then group them together.

　　For instructions on how to make the stems and leaves, look。